How to configure DT85G

The dataTaker DT85 16 channel general purpose data logger

How to configure DT85G

Postby Yogi6719 » Fri Nov 24, 2017 9:55 pm

I have to configure DT85G to measure Voltage in mili volt in one channel and current in micro ampere in second channel every second . Please help me.
Yogi6719
Newbie
 
Posts: 1
Joined: Fri Nov 24, 2017 9:38 pm

Re: How to configure DT85G

Postby Rudy Gunawan » Mon Nov 27, 2017 2:28 pm

Hi Yogi,

When you started dEX web interface, and go to "Configure the Logger" you will see one schedule (Schedule_1 (A)) has been preconfigured to run every 5 seconds.
Please change this interval into 1 second according to your requirement.

Then we can add some channels as a member of schedule A.
While the highlight cursor in schedule A:
- Click Add followed by Measurement then Voltage to add voltage channel.
- Do the same but with Current to add current channel.

After this process you already create one voltage channel and one current channel.
You can then send the program to dataTaker by clicking File followed by Save to Logger.

Best regards,
Rudy Gunawan
Rudy Gunawan
Guru
 
Posts: 423
Joined: Sun Apr 29, 2012 12:28 am


Return to DT85

Who is online

Users browsing this forum: No registered users and 2 guests

cron