Alas our old reliable DT50 passed away after the power supply suffered an over-voltage incident.
We had regularly gathered data each month still using DeTerminal and an 486DX33 Compaq laptop and with a few changes to the old job program the DT80 is performing well.
There was a command in the old program that I have commented out and after a quick look through the DT50 manual I could not find a reference to it.
The command is one line and is...
I have found a reference to a wait state in the DT80 user manual but I am unsure if this is what the command is or if it does need to be added in whatever is its updated state.
Any help would be appreciated